Jiaozuo brake

Warning: The thruster should be reliably grounded according to electrical specifications! Attention: When wiring, cut off the power supply and erect a sign at the power switch that reads "Someone is working, do not switch on",

Until the wiring is completed.

When wiring, remove the cover of the thruster junction box (there is a wiring diagram on the reverse side), and connect the three-phase power line (phase sequence is not required) and grounding wire as required. Then cover the junction box cover and tighten the screws

ED electric hydraulic thruster

Ed23/5, Ed30/5, Ed50/6, Ed80/6, Ed121/6, Ed201/6, Ed23/5, Ed30/5, Ed50/6, Ed80/6, Ed121/6, Ed201/6, Ed301/6

Mainly used as an operating component for the YWZ4, YWZ5, YWZ8, YWZ9, YWL.YW.YWZP series electric hydraulic block brakes. It is widely used in industries such as lifting transportation, metallurgy, mining, port electric hydraulic block brake ports, and construction.

Usage conditions:

Environmental temperature: DB-25 hydraulic oil should be used at -20 ℃ -50 ℃, and YH-10 aviation hydraulic oil should be used below -20 ℃, without installing a heater; When using DB-25 hydraulic oil, a heater must be installed. Continuous operation S1, intermittent operation S3-60%.

Voltage and frequency: three-phase AC 380V/50 (60) Hz. Our company can also provide other products with different frequencies and voltages. Please negotiate and order if needed.

Three-phase AC asynchronous motor, in accordance with the regulations of (G8755-2000), with detailed performance in the "Technical Data". Insulation level: F level, electrical protection level: IP65.

Cable: The cross-sectional area of the wire can reach 4X2.5mm ²。

Efficient anti-corrosion products: Used in situations where there are corrosive media and high relative humidity in the air, which may result in condensation. The motor adopts vacuum injection molded stator and is painted with special anti-corrosion paint. The series of products can be provided with anti-corrosion products, and users can contact the company if they need them

special requirements

According to requirements, different voltage and frequency levels of thrusters can be provided. The special treated three proof motor is suitable for "TH" type, "AH" type, and hybrid type requirements.

Selection of installation method

Vertical installation: The piston rod connecting block faces upwards. Horizontal installation and any position in the middle: The installation form is shown in the following figure.

All push rods and connecting blocks of the thrusters can rotate. The Ed50-Ed301 mounting base can be used for 90. Rotate. The Ed23 and Ed30 mounting bases can also provide 900 rotations, but the installation height dimension A is increased by 8mm (specify when ordering). Regardless of the installation position, the piston rod cannot withstand radial forces to avoid affecting its effectiveness and lifespan.